For the FOB to work, the homeowner must have purchased a Linear MDR/U DNR00100 1-Channel Plug-in Receiver accessory when the new FOBs where issued.
The receivers are available on Amazon … click to view
To program an additional FOB to operate the garage door opener:
- A small grey Linear receiver box should be plugged into one of the electrical outlets in the ceiling by the garage door opener.
- There is a learn button and light on the side of the box. Press and release the button. The learn indicator will light up.
- Within 15 seconds while the indicator light is still lit, hold the FOB that you want to program up to the box. Press and hold the smaller grey button on the FOB (or one of the other two small buttons) until the light start to flash.
- The FOB should now be programmed.
How to replace KEY FOB batteries … replace Linear ACT-34B batteries
This maintenance schedule was developed to provide consistency in maintaining HMHC property. click to view template (last updated August 2017)
This report (Funding MODEL 1) was adopted at the AGM September 30, 2015 to provide further consistency in maintaining HMHC Property in addition to the HMHC Maintenance Schedule above. click to view template (last updated July 2016)
Here is a the Installation and User Guide for programming the outside garage door lights.
To view or print … Click Here
The HMHC authorized storm door can be purchased through Rona. The make is AluminArt model Regal Deluxe colour Sandstone. The local Rona should know all about them, just say it’s for Halcyon. They didn’t used to have the Sandstone colour in stock but since Halcyon homeowners have purchased so many of them they probably do now. I’m not sure of the cost today but they used to be about $350.00. Can anyone provide a current price? When you purchase the door you should also purchase two good quality 2×3 about 6-8 feet because you will have to build out the door frame. You should also note that the doors are not pre-drilled as they can be installed to either open to the left or the right. so you will have to drill for hinge placement, handle, lock, and the 2 closing rams.