Programming a FOB to open garage door

For the FOB to work, the homeowner must have purchased a Linear MDR/U DNR00100 1-Channel Plug-in Receiver accessory when the new FOBs where issued.

The receivers are available on Amazon … click to view

To program an additional FOB to operate the garage door opener:

  1. A small grey Linear receiver box should be plugged into one of the electrical outlets in the ceiling by the garage door opener.
  2. There is a learn button and light on the side of the box. Press and release the button. The learn indicator will light up.
  3. Within 15 seconds while the indicator light is still lit, hold the FOB that you want to program up to the box. Press and hold the smaller grey button on the FOB (or one of  the other two small buttons) until the light start to flash.
  4. The FOB should now be programmed.

How to replace KEY FOB batteries … replace Linear ACT-34B batteries

 

Comments are closed



  • *** NOTICE TO RESIDENTS – STAND FOR ELECTION ***
    The Board of Directors is now accepting applications for a position on the 2020-2021 Halcyon Meadows Homeowners’ Corporation Board. This can be a very rewarding experience and your opportunity to “give back to your community”. If you feel you could make a positive contribution to Halcyon Meadows, please consider letting your name stand. The form is available in the mail room or on the website under forms. Stand for Election forms must be completed and left in the HMHC Mail Slot in the mail room no later than 8:00 pm on August 31st, 2020.